The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear door belt moulding removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
67674A
3.REMOVE REAR DOOR FRAME GARNISH
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
67604
5.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68174A
6.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP
68197A
7.REMOVE REAR DOOR BELT FRONT SEAL
68199
8.REMOVE REAR DOOR BELT REAR SEAL
67842E
9.REMOVE REAR DOOR SERVICE HOLE COVER (w/ Rear Speaker)
67842E
10.REMOVE REAR DOOR SERVICE HOLE COVER (w/o Rear Speaker)
68152C
11.REMOVE REAR DOOR GLASS RUN
67408E
12.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
68104
13.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
68230C
14.REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
|
Protective Tape |
Apply protective tape around the rear door glass outer weatherstrip assembly.
|
Remove in this Direction |
Disengage the claws to remove the rear door glass outer weatherstrip assembly as shown in the illustration.