Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK › 2020.03–2020.07
RM36W0E _58 Vehicle Interior _088479 DOOR LOCK _0421642 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front door lock assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
·

Door glass

·

Door glass run


Initialize power window control system
·

Auto up and down function

·

Jam protection function

·

Catch protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Window open warning function


(Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system


-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the power switch is turned to on (IG), the servo motor standard position is recognized. -


·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the RH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



Hide 67491A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Hide 5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Hide 67655 6.REMOVE FRONT DOOR TRIM GARNISH

Hide 67601 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 68171B 8.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP

Hide 67837A 9.REMOVE FRONT DOOR VENT SEAL

Hide 67855B 10.REMOVE FRONT DOOR PANEL PROTECTOR

Hide 67831 11.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 68101 12.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Hide 68141C 13.REMOVE FRONT DOOR GLASS RUN

Hide 67403F 14.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

Hide 69210 15.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side)

Hide 69510 16.REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)

Hide 69310 17.REMOVE FRONT DOOR LOCK ASSEMBLY

a.
B565992

Disconnect the connector.


b.

Using a T30 "TORX" socket wrench, remove the 3 screws.


c.
B565993

Disconnect the front door lock open rod as shown in the illustration.


d.

Remove the front door lock assembly.


e.

When reusing the front door lock assembly:

i.
B576088

Remove the door lock wiring harness seal from the front door lock assembly.



Hide 69710B 18.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

a.
B565995C02
0.844,0.917 0.396,0.917 true 0.208,0.823 0.417,1.042 0.208,0.219 10 true *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.


b.
B576089

Disengage the guide to remove the front door lock remote control cable assembly from the front door lock assembly.


Hide 69750C 19.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

a.
B576090

Disengage the guide to remove the front door inside locking cable assembly from the front door lock assembly.