Home › Engine / Hybrid System › M15A-FKS (COOLING) › THERMOSTAT
RM36W0E _51 Engine / Hybrid System _088541 M15A-FKS COOLING _0421816 THERMOSTAT A

M15A-FKS COOLING  THERMOSTAT  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16031 1.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.

Install a new gasket to the water inlet with thermostat sub-assembly.

HINT:

Be sure to clean the contact surfaces.



b.

Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the water inlet with thermostat sub-assembly connector.


d.

Connect the No. 6 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.


e.

Using an 8 mm socket wrench, connect the bracket to the engine water pump assembly (water inlet housing) with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


f.

Connect the engine water pump assembly (water inlet housing) connector.


Hide 16572D 2.CONNECT NO. 2 RADIATOR HOSE

a.

Connect the No. 2 radiator hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.


Hide 5.ADD ENGINE COOLANT

Hide 51451A 7.INSTALL CENTER ENGINE UNDER COVER