This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
16031
1.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Install a new gasket to the water inlet with thermostat sub-assembly.
Be sure to clean the contact surfaces.
Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.
Connect the No. 6 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
Using an 8 mm socket wrench, connect the bracket to the engine water pump assembly (water inlet housing) with the bolt.
Connect the engine water pump assembly (water inlet housing) connector.
16572D
2.CONNECT NO. 2 RADIATOR HOSE
Connect the No. 2 radiator hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
17111
3.INSTALL INTAKE MANIFOLD
4.ADD ENGINE COOLANT (for Engine)
5.INSPECT FOR COOLANT LEAK (for Engine)
51451A
6.INSTALL CENTER ENGINE UNDER COVER