Home › Drivetrain › K320 (MULTIDRIVE / CVT) › TCM
RM36W0E _52 Drivetrain _087836 K320 MULTIDRIVE / CVT _0422070 TCM A

K320 MULTIDRIVE / CVT  TCM  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

After performing the update ECU security key procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 89539N 1.INSTALL NO. 2 TRANSMISSION CONTROL ECU BRACKET

a.

Install the No. 2 transmission control ECU bracket to the TCM with the 2 screws.

Torque:
5.8 N*m (59 kgf*cm, 51 in.*lbf)


Hide 89539M 2.INSTALL NO. 1 TRANSMISSION CONTROL ECU BRACKET

a.

Install the No. 1 transmission control ECU bracket to the TCM with the 2 screws.

Torque:
5.8 N*m (59 kgf*cm, 51 in.*lbf)


Hide 89535B 3.INSTALL TCM

a.

Install the TCM to the continuously variable transaxle assembly with the 2 bolts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


b.
C429253C02
0,0 0,0 false
V113147

Install in this Direction


Connect the TCM connector to rotate the lever and engage the claw.

HINT:

Rotate the lever until the claw of the TCM connector makes a click sound.



c.

Engage the clamp to connect the engine wire to the No. 2 transmission control ECU bracket.


Hide 74404A 4.INSTALL BATTERY CLAMP SUB-ASSEMBLY

Hide 17701 6.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 7.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 51442C 8.INSTALL ENGINE UNDER COVER LH

Hide 51451A 9.INSTALL CENTER ENGINE UNDER COVER

Hide 10.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 13. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART