31410
1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY
Install a new clutch master cylinder gasket to the clutch master cylinder assembly.
Install the clutch master cylinder assembly to the vehicle body with the 2 nuts.
31453A
2.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN
87211
3.INSTALL NO. 1 AIR DUCT
55606
4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
31481
5.CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
| *a | Torque Wrench Fulcrum Length |
Using a 10 mm union nut wrench, connect the clutch master cylinder to flexible hose tube to the clutch master cylinder assembly.
Do not kink or damage the clutch master cylinder to flexible hose tube.
Do not allow any foreign matter such as dirt or dust to enter the clutch master cylinder to flexible hose tube from the connecting part.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):
13.4 N*m (137 kgf*cm, 10 ft.*lbf)
31434E
6.CONNECT NO. 1 CLUTCH RESERVOIR HOSE
| *a | View A |
| *b | Top of Vehicle |
| *c | Paint Mark (Top of Vehicle) |
| *d | 0 to 2 mm (0 to 0.0787 in.) |
Connect the No. 1 clutch reservoir hose to the clutch master cylinder assembly and slide the hose clip to secure it.
Make sure that the paint mark of the No. 1 clutch reservoir hose is within the location shown in the illustration.
Make sure that the claws of the hose clip are within the location shown in the illustration.
7.BLEED CLUTCH LINE
8.INSPECT FOR BRAKE FLUID LEAK
9.INSPECT BRAKE FLUID LEVEL IN RESERVOIR
55701J
10.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
55735A
11.INSTALL WATER GUARD PLATE LH
55815E
12.INSTALL FRONT NO. 1 VENTILATOR SEAL
13.INSTALL WINDSHIELD WIPER MOTOR AND LINK
14.INSPECT CLUTCH PEDAL