1.TEMPORARILY INSTALL AIR CONDITIONER UNIT ASSEMBLY
Temporarily install the air conditioner unit assembly to the instrument panel reinforcement assembly with the 3 bolts.
2.INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONER UNIT ASSEMBLY
Engage the guides to install the instrument panel reinforcement assembly with air conditioner unit assembly as shown in the illustration.
|
Install in this Direction | - | - |
Install the 6 bolts.
Temporarily install the nut.
Do not fully tighten the nut.
55306A
3.INSTALL NO. 1 INSTRUMENT PANEL BRACE SUB-ASSEMBLY
Install the No. 1 instrument panel brace sub-assembly with the bolt and nut.
Temporarily install the screw.
Do not fully tighten the screw.
4.INSTALL AIR CONDITIONER UNIT ASSEMBLY
Tighten the 3 bolts, screws and nut in the order shown in the illustration to install the air conditioner unit assembly.
82141
5.INSTALL INSTRUMENT PANEL WIRE
Engage the each clamp to install the instrument panel wire.
| *A | for Cold Area Specification Vehicles | - | - |
| *a | Guide | *b | Clamp |
Connect the each connector.
for Cold Area Specification Vehicles:
Engage the guide to connect the ground wire with the bolt to the No. 1 instrument panel brace sub-assembly.
Connect the connector.
Connect the instrument panel wire with the bolt.
Install the 4 ground wires with the 4 bolts.
for Manual Air Conditioning System:
Engage the clamp.
Connect the connector.
for Automatic Air Conditioning System:
Engage the clamp.
Connect the 2 connectors.
for Manual Air Conditioning System Single Layer Type:
Engage the clamp.
Connect the 2 connectors.
for Manual Air Conditioning System Double Layer Type:
Engage the clamps.
Connect the 3 connectors.
for Automatic Air Conditioning System:
Engage the clamp.
Connect the connector.
Install the instrument panel junction block assembly RH with the 2 nuts.
Engage the clamps.
6.INSTALL TELEMATICS TRANSCEIVER WITH BRACKET (w/ Telematics Transceiver)
7.INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY WITH MULTIPLEX NETWORK BODY ECU
55308B
8.INSTALL NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY (for TFTM Made)
Install the No. 3 instrument panel to cowl brace sub-assembly with the bolt and nut.
83108
9.INSTALL METER MIRROR SUB-ASSEMBLY (w/ Headup Display)
88539J
10.INSTALL DRAIN COOLER HOSE
Connect the drain cooler hose.
55216C
11.INSTALL NO. 4 DASH PANEL INSULATOR PAD
Engage the clips to install the No. 4 dash panel insulator pad.
87212
12.INSTALL NO. 1 REAR AIR DUCT (for Cold Area Specification Vehicles)
87212H
13.INSTALL NO. 4 REAR AIR DUCT (for Cold Area Specification Vehicles)
87212F
14.INSTALL NO. 2 REAR AIR DUCT (for Cold Area Specification Vehicles)
58510D
15.INSTALL FRONT FLOOR CARPET ASSEMBLY (for Cold Area Specification Vehicles)
Install the front floor carpet assembly with the 2 clips as shown in the illustration.
87212J
16.INSTALL NO. 5 REAR AIR DUCT (for Cold Area Specification Vehicles)
87212G
17.INSTALL NO. 3 REAR AIR DUCT (for Cold Area Specification Vehicles)
58510D
18.INSTALL FRONT FLOOR CARPET ASSEMBLY (except Cold Area Specification Vehicles)
Install the front floor carpet assembly with the 2 clips as shown in the illustration.
77306
19.INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for Cold Area Specification Vehicles)
58569D
20.INSTALL FRONT FLOOR CAUTION PLATE COVER (for Cold Area Specification Vehicles)
Engage the guide and claw to install the front floor caution plate cover.
21.INSTALL FRONT SEAT ASSEMBLY LH
22.INSTALL FRONT SEAT ASSEMBLY RH
Use the same procedure as for the LH side.
55084E
23.INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Engage the clamp to install the No. 1 heater to register duct sub-assembly.
Install the clip.
55085
24.INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Engage the clamp to install the No. 2 heater to register duct sub-assembly.
Install the clip.
55086A
25.INSTALL CENTER HEATER TO REGISTER DUCT SUB-ASSEMBLY
Engage the clamp to install the center heater to register duct sub-assembly.
Install the clip.
26.INSTALL STEERING COLUMN ASSEMBLY
87211
27.INSTALL NO. 1 AIR DUCT
Engage the claws to install the No. 1 air duct.
Install the 2 bolts.
28.INSTALL INSTRUMENT PANEL ASSEMBLY
87245
29.INSTALL INLET HEATER WATER HOSE
16290F
30.INSTALL NO. 3 WATER BY-PASS HOSE ASSEMBLY
88716A
31.INSTALL COOLER REFRIGERANT LIQUID PIPE A (except 1KR-FE)
88707
32.INSTALL SUCTION PIPE SUB-ASSEMBLY (except 1KR-FE)
88710G
33.INSTALL NO. 2 AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY (for 1KR-FE)
55701J
34.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
Install outer cowl top panel sub-assembly with the 12 bolts.
Engage the clamp.
for Cold Area Specification Vehicles:
Connect the connector.
Engage the clamps.
55815E
35.INSTALL NO. 1 FRONT VENTILATOR SEAL
Engage the claws to install the No. 1 front ventilator seal.
55735A
36.INSTALL WATER GUARD PLATE LH
Engage the claws to install the water guard plate LH.
37.INSTALL WINDSHIELD WIPER MOTOR AND LINK
38.ADD ENGINE COOLANT
for 1KR-FE:
for M15A-FKS:
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE COOLANT (for Engine)>REPLACEMENT
39.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
for HFC-134a(R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf(R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFO-1234yf(R1234yf))>REPLACEMENT
40.INSPECT FOR COOLANT LEAK
for 1KR-FE:
Click hereEngine / Hybrid System>1KR-FE (COOLING)>COOLING SYSTEM>ON-VEHICLE INSPECTION
for M15A-FKS:
Click hereEngine / Hybrid System>M15A-FKS (COOLING)>COOLING SYSTEM>ON-VEHICLE INSPECTION
for M15A-FXE:
Click hereEngine / Hybrid System>M15A-FXE (COOLING)>COOLING SYSTEM>ON-VEHICLE INSPECTION
41. WARM UP ENGINE (for Gasoline Model)
for HFC-134a(R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf(R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFO-1234yf(R1234yf))>REPLACEMENT
42.WARM UP COMPRESSOR (for HV Model)
for HFC-134a(R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf(R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFO-1234yf(R1234yf))>REPLACEMENT
43.INSPECT FOR REFRIGERANT LEAK
for HFC-134a(R134a):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFC-134a(R134a))>REPLACEMENT
for HFO-1234yf(R1234yf):
Click hereVehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT (for HFO-1234yf(R1234yf))>REPLACEMENT
51451A
44.INSTALL CENTER ENGINE UNDER COVER (for Full Cover Type)
45. INITIALIZATION SERVO MOTOR (for Automatic Air Conditioning System)
46.PERFORM REGISTRATION (w/ Stop And Start System)