Home › Engine / Hybrid System › 1KR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2020.07
RM36W0E _51 Engine / Hybrid System _091054 1KR-FE ENGINE CONTROL _0431746 SFI SYSTEM C

1KR-FE ENGINE CONTROL  SFI SYSTEM  P211172  Throttle Actuator "A" Control System Actuator Stuck Open  


DESCRIPTION

Refer to DTC P060E87.

Click hereEngine / Hybrid System>1KR-FE (ENGINE CONTROL)>SFI SYSTEM>P060E87

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory DTC Output from Priority
P211172 Throttle Actuator "A" Control System Actuator Stuck Open Both of the following conditions are met (1 trip detection logic):
·

DTC P211173 is not output

·

The throttle does not close when current is not applied to the throttle motor


Throttle body with motor assembly Comes on DTC stored Engine A

CONFIRMATION DRIVING PATTERN

DTC P211172 is detected when the ignition switch is ON.

CAUTION / NOTICE / HINT

NOTICE:

After replacing the throttle body with motor assembly, perform electronic throttle learning and idle learning.

Click hereEngine / Hybrid System>1KR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.


PROCEDURE

1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (VISUALLY CHECK THROTTLE VALVE)

Pre-procedure1

a.

Remove the throttle body with motor assembly.

HINT:

Click hereEngine / Hybrid System>1KR-FE (ENGINE CONTROL)>THROTTLE BODY>REMOVAL



Procedure1

b.

Check for contamination between the throttle valve and the housing, and check that the throttle valve moves smoothly.

OK:

No contamination between the throttle valve and the housing, and the throttle valve moves smoothly.



Result:
Proceed to
OK
NG


Post-procedure1

c.

None.



OK

2.REPLACE THROTTLE BODY WITH MOTOR ASSEMBLY

NG

CLEAN THROTTLE BODY WITH MOTOR ASSEMBLY
HINT:

Perform electronic throttle learning and idle learning.

Click hereEngine / Hybrid System>1KR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION



2.REPLACE THROTTLE BODY WITH MOTOR ASSEMBLY

NEXT

3.PERFORM IDLE LEARNING
3.PERFORM IDLE LEARNING

NEXT

4.CLEAR DTC
4.CLEAR DTC

Pre-procedure1

a.

None.


Procedure1

b.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 372

Result:
Proceed to
NEXT


Post-procedure1

c.

Turn the ignition switch off and wait for at least 30 seconds.



NEXT

5.CHECK WHETHER DTC OUTPUT RECURS (DTC P211172)
5.CHECK WHETHER DTC OUTPUT RECURS (DTC P211172)
a.

Read the DTCs.

Powertrain > Engine > Trouble Codes
50001 372
OK:

DTCs are not output.



Result:
Proceed to
NEXT



NEXT

END