The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission case oil seal and transaxle case oil seal removal/installation are shown below.
1.DRAIN MANUAL TRANSAXLE OIL
2.REMOVE FRONT DRIVE SHAFT ASSEMBLY
3.REMOVE TRANSMISSION CASE OIL SEAL
Using SST, remove the transmission case oil seal.
4.REMOVE TRANSAXLE CASE OIL SEAL
Using SST, remove the transaxle case oil seal.
5.INSTALL TRANSMISSION CASE OIL SEAL
Coat the lip of a new transmission case oil seal with MP grease.
| *a | Depth |
Using SST and a hammer, install the new transmission case oil seal.
2.1 to 3.1 mm (0.083 to 0.122 in.)
Do not damage the oil seal lip.
| *a | Correct |
| *b | Incorrect |
| *c | Outer Lip |
Make sure that the outer lip of the transmission case oil seal is not pinched by SST.
Do not allow foreign matter to attach to the inner lip and outer lip of the transmission case oil seal.
Do not install the transmission case oil seal at an angle.
Do not remove the grease from the inner lip and outer lip of the transmission case oil seal.
6.INSTALL TRANSAXLE CASE OIL SEAL
Coat the lip of a new transaxle case oil seal with MP grease.
| *a | Depth |
Using SST and a hammer, install the new transaxle case oil seal.
1.7 to 2.7 mm (0.067 to 0.106 in.)
Do not damage the oil seal lip.
| *a | Correct |
| *b | Incorrect |
| *c | Outer Lip |
Make sure that the outer lip of the transmission case oil seal is not pinched by SST.
Do not allow foreign matter to attach to the inner lip and outer lip of the transmission case oil seal.
Do not install the transmission case oil seal at an angle.
Do not remove the grease from the inner lip and outer lip of the transmission case oil seal.
7.INSTALL FRONT DRIVE SHAFT ASSEMBLY