After performing the update ECU security key procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal.
44785
1.INSTALL BRAKE BOOSTER GASKET
Install a new brake booster gasket to the brake booster with master cylinder assembly.
47210L
2.INSTALL BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
| *a | ECU Connector |
| *b | Connector |
| *c | Boot |
| *d | Brake Master Cylinder Push Rod Clevis |
| *e | Brake Master Cylinder Reservoir Assembly |
Install the brake booster with master cylinder assembly with the 4 nuts.
Tighten the nuts in the order shown in the illustration.
Do not kink or damage the brake lines.
Do not carry the brake booster with master cylinder assembly by the parts shown in the illustration.
Be careful not to allow brake fluid to enter the connector.
If installing a new brake booster with master cylinder assembly, do not remove the hole plugs before connecting the brake lines because the brake booster with master cylinder is filled with brake fluid.
47264A
3.INSTALL PUSH ROD PIN
47101A
4.INSTALL BRAKE PEDAL RETURN SPRING
55606
5.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
6.CONNECT BRAKE LINE
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, connect the 2 brake lines to the brake master cylinder sub-assembly.
Do not kink or damage the brake lines.
Do not allow the brake lines to twist or interfere with other parts or the vehicle body during tightening.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):
17.4 N*m (177 kgf*cm, 13 ft.*lbf)
Engage the 3 clamps to install a new No. 1 brake tube clamp.
82111
7.INSTALL ENGINE ROOM MAIN WIRE
|
Lock the lock lever |
|
Connect the connector |
Connect the connector to the brake booster with master cylinder assembly and lock the lock lever as shown in the illustration.
Make sure that the connector is locked securely.
Make sure that the connector can be connected smoothly. Do not allow water, oil or dirt to enter the connector.
Connect the connector to the brake master cylinder reservoir assembly.
Engage the clamp to install the No. 2 engine room wire to the brake booster with master cylinder assembly.
Connect the connector to the brake booster with master cylinder assembly.
Connect the connector to the No. 2 engine room wire.
8.INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
9.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
10. UPDATE ECU SECURITY KEY
11.BLEED BRAKE LINE
12.INSPECT AND ADJUST BRAKE PEDAL
13.PERFORM INITIALIZATION AND CALIBRATION
14. CHECK AND CLEAR DTCS
15. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART