The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the horn button assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for 1KR-FE:
Click hereGeneral>MAINTENANCE>1KR-FE AUXILIARY BATTERY>REMOVAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
55479E
3.REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL GARNISH
55432B
4.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL
55407B
5.REMOVE SWITCH HOLE BASE SUB-ASSEMBLY
33504F
6.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for CVT)
33504F
7.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
33554
8.REMOVE SHIFT LEVER CAP (for CVT)
58810J
9.REMOVE FRONT CONSOLE BOX SUB-ASSEMBLY
67913B
10.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62111C
11.REMOVE COWL SIDE TRIM BOARD RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
55607
12.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62311B
13.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
55317E
14.REMOVE NO. 1 INSTRUMENT SIDE PANEL
55550
15.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
55433B
16.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
82878
17.REMOVE ECU INTEGRATION BOX RH
Disengage clamps and disconnect the 7 connectors.
Remove the bolt and 2 nuts.
Disengage the claws to remove the ECU integration box RH.
89111
18.REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)
|
Remove in this Direction |
Disengage the claws to remove the central gateway ECU (network gateway ECU) as shown in the illustration.
If the ECU integration box LH is deformed or damaged, replace it.
Do not bend the claws more than necessary.