Use the same procedure for TMC Made and TMMF Made vehicles.
The procedure below is for TMMF Made Type vehicles.
84306
1.REMOVE SPIRAL CABLE SUB-ASSEMBLY
84650
2.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
84329
3.REMOVE TURN SIGNAL SWITCH
84319
4.REMOVE STEERING WHEEL SWITCH HOUSING
Using pliers, expand the clamp as shown in the illustration.
| *a | Protective Tape |
|
Remove in this Direction |
While holding the clamp expanded, using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the steering wheel switch housing as shown in the illustration.