Home › Engine / Hybrid System › 1KR-FE (COOLING) › RADIATOR › from 2020.07
RM36W0E _51 Engine / Hybrid System _091037 1KR-FE COOLING _0432969 RADIATOR A

1KR-FE COOLING  RADIATOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B473126

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL

CAUTION:
·
B422343

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If an SRS part is accidentally deployed, it may cause a serious injury.



Hide 51451A 3.REMOVE CENTER ENGINE UNDER COVER

Hide 4.DRAIN ENGINE COOLANT

Hide 6.REMOVE HEADLIGHT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 16681A 7.REMOVE RADIATOR UPPER AIR GUIDE PLATE

Hide 52611 8.REMOVE FRONT BUMPER ENERGY ABSORBER

Hide 52131A 9.REMOVE FRONT BUMPER REINFORCEMENT

Hide 17701 11.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

a.
A477649C01
0,0 0,0 false

Slide the clip and disconnect the No. 2 ventilation hose from the air cleaner hose.


b.

Loosen the hose clamp and disconnect the air cleaner hose from the throttle body with motor assembly.


c.

Disengage the 3 grommets to remove the air cleaner case sub-assembly from the vehicle body.


Hide 53213C 12.REMOVE UPPER FRONT RADIATOR SUPPORT

a.
A470508C01
0.021,0.052 0.24,0.24 0.219,0.188 10 true *A 0.042,2.51 0.26,2.698 0.219,0.188 10 true *B
*A for RHD
*B for LHD


Disconnect the hood lock control cable assembly.


b.

Disconnect the 2 airbag connectors.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



c.

Disengage the 3 clamps and disconnect the wire harness.


d.

Remove the bolt and disconnect the wire harness.


e.

Disconnect the connector.


f.

When reusing upper front radiator support:

i.
A470511

Place match marks as shown in the illustration.



g.

Remove the 4 bolts and upper front radiator support from the front side member bracket sub-assembly.


Hide 16695A 13.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE LH

Hide 16691A 14.REMOVE FRONT RADIATOR SIDE AIR GUIDE PLATE RH

Hide 16562L 15.REMOVE NO. 2 RADIATOR TO SUPPORT SEAL

Hide 16561D 16.REMOVE NO. 1 RADIATOR TO SUPPORT SEAL

a.
A465150

Disengage the claw and guide to remove the No. 1 radiator to support seal.


Hide 16595D 17.REMOVE NO. 1 RADIATOR AIR GUIDE LH

a.
A465151

Disengage the 2 clamps and disconnect the wire harness.


b.

Disengage the claw and guide to remove the No. 1 radiator air guide LH.


Hide 16261G 18.DISCONNECT NO. 1 WATER BY-PASS HOSE

a.
A465152

Disengage the clamp.


b.

Slide the clip and disconnect the No. 1 water by-pass hose from the radiator assembly.


Hide 19.DISCONNECT RADIATOR RESERVOIR TANK HOSE

a.
A465153

Disconnect the radiator reservoir tank hose from the water filler sub-assembly.


Hide 16502 20.SEPARATE WATER FILLER SUB-ASSEMBLY

a.
A465154

Disconnect the connector.


b.

Disengage the 2 clamps and disconnect the wire harness.


c.
A465155

Disengage the 2 bolts to separate the water filler sub-assembly from the fan shroud.


Hide 16573B 21.DISCONNECT NO. 3 RADIATOR HOSE

a.
A465156

Slide the clip and disconnect the No. 3 radiator hose from the radiator assembly.


Hide 16572D 22.DISCONNECT NO. 2 RADIATOR HOSE

a.
A465157

Slide the clip and disconnect the No. 2 radiator hose from the radiator assembly.


Hide 88460 23.SEPARATE COOLER CONDENSER ASSEMBLY

a.
A465246

Disengage the 2 claws and 2 guides to separate the cooler condenser assembly from the radiator assembly.

NOTICE:

Do not damage the cooler condenser assembly or radiator assembly when separating the cooler condenser assembly.



Hide 16400 24.REMOVE RADIATOR ASSEMBLY

a.
A465247

Remove the radiator assembly together with the fan shroud from the vehicle body.

NOTICE:

Do not apply excessive force to the cooler condenser assembly or pipe when removing the radiator assembly with the fan shroud.



b.
A465248

Disengage the 2 claws and 2 guides to remove the fan shroud from the radiator assembly.

NOTICE:

Do not damage the radiator assembly when removing the fan shroud.



Hide 16523A 25.REMOVE RADIATOR SUPPORT CUSHION

a.
A465249

Remove the 2 radiator support cushions from the radiator assembly.


Hide 16535 26.REMOVE LOWER RADIATOR SUPPORT

a.
A465250

Remove the 2 lower radiator supports from the radiator assembly.


Hide 27.REMOVE RADIATOR DRAIN COCK PLUG

a.
A465251

Remove the radiator drain cock plug.


b.

Remove the O-ring from the radiator drain cock plug.