Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0432441 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made)  C051279  Right Rear Wheel Speed Sensor Mechanical Linkage Failure  


DESCRIPTION

The skid control ECU (brake actuator assembly) calculates the various wheel speeds based on signals from each type of sensor.

By comparing the calculated wheel speed values with the output values of each wheel speed sensor signal, the skid control ECU (brake actuator assembly) checks that each wheel speed sensor is functioning correctly.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C051279 Right Rear Wheel Speed Sensor Mechanical Linkage Failure At a vehicle speed of 14 km/h (9 mph) or more, the wheel speed sensor signal output value continuously differs from the control value calculated by the skid control ECU.
·

Rear speed sensor RH (rear axle hub and bearing assembly RH)

·

Rear speed sensor rotor RH (rear axle hub and bearing assembly RH)


Brake

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made)>TEST MODE PROCEDURE

·

After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made)>TEST MODE PROCEDURE



HINT:

The rear speed sensor RH and rear speed sensor rotor RH are incorporated into the rear axle hub and bearing assembly RH.

If the rear speed sensor RH and/or rear speed sensor rotor RH need to be replaced, replace the rear axle hub and bearing assembly RH.


PROCEDURE

1.CHECK DTC
a.

Operate the GTS to read the DTCs.

Chassis > Brake > Trouble Codes
50001 435

b.

Check the details of the DTCs.

HINT:

When DTC C051218, C051219, C05121F, C051223 and/or C051224 are output together with DTC C051279, inspect and repair the trouble areas indicated by DTC C051218, C051219, C05121F, C051223 and/or C051224 first.



Result:
Result Proceed to
Only C051279 is output A
C051218, C051219, C05121F, C051223 and/or C051224 are output together B



A

2.PRE-CHECK

B

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS

2.PRE-CHECK
a.

Check that all 4 tires are of correct size, are inflated to the correct pressure, and do not show excessive signs of wear.

HINT:

If a tire is deformed or an incorrectly sized tire or wheel is installed, this DTC may be stored.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION



Result:
Proceed to
NEXT



NEXT

3.CHECK FREEZE FRAME DATA (FL WHEEL SPEED, FR WHEEL SPEED, RL WHEEL SPEED, RR WHEEL SPEED, VEHICLE SPEED)
3.CHECK FREEZE FRAME DATA (FL WHEEL SPEED, FR WHEEL SPEED, RL WHEEL SPEED, RR WHEEL SPEED, VEHICLE SPEED)

Pre-procedure1

a.

Using the GTS, select a DTC to display the Freeze Frame Data.

HINT:

Using to the freeze frame data, the approximate vehicle conditions that were present when the DTC was stored can be determined.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made)>FREEZE FRAME DATA



Procedure1

b.

Read the freeze frame data of DTC C051279.

Chassis > Brake
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Wheel Speed Front wheel speed sensor RH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
FL Wheel Speed Front wheel speed sensor LH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RR Wheel Speed Rear wheel speed sensor RH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RL Wheel Speed Rear wheel speed sensor LH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
Vehicle Speed Maximum wheel speed sensor reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
Chassis > Brake > DTC(C051279) > Freeze Frame Data
Tester Display
FR Wheel Speed
FL Wheel Speed
RR Wheel Speed
RL Wheel Speed
Vehicle Speed
50040 435 13,14,15,16,51 C051279

Post-procedure1

c.

None


Result:
Proceed to
NEXT



NEXT

4.READ VALUE USING GTS (FL WHEEL SPEED, FR WHEEL SPEED, RL WHEEL SPEED, RR WHEEL SPEED, VEHICLE SPEED)
4.READ VALUE USING GTS (FL WHEEL SPEED, FR WHEEL SPEED, RL WHEEL SPEED, RR WHEEL SPEED, VEHICLE SPEED)

Pre-procedure1

a.

Start the engine.


Procedure1

b.

Select the Data List on the GTS.

Chassis > Brake > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Wheel Speed Front wheel speed sensor RH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
FL Wheel Speed Front wheel speed sensor LH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RR Wheel Speed Rear wheel speed sensor RH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RL Wheel Speed Rear wheel speed sensor LH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
Vehicle Speed Maximum wheel speed sensor reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
Chassis > Brake > Data List
Tester Display
FR Wheel Speed
FL Wheel Speed
RR Wheel Speed
RL Wheel Speed
Vehicle Speed
50003 435 13,14,15,16,36

c.

Perform a road test under the same malfunction conditions recreated based on the Freeze Frame Data or customer problem analysis.


d.

Check the value of Wheel Speed and Vehicle Speed.

OK:

The value of each Wheel Speed and Vehicle Speed changes in accordance with vehicle speed and the maximum difference between any 2 sensors is less than 6%.


HINT:

If the result of the road test is within the specified range, it is possible that this DTC was stored due to a particular situation.



Post-procedure1

e.

Turn the ignition switch off.


Result:
Proceed to
OK
NG



OK

NG

REPLACE REAR AXLE HUB AND BEARING ASSEMBLY RH