1. CHECK STEERING EFFORT (TORQUE)
These service operations may affect the SRS airbags. Be sure to read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Stop the vehicle on a level, paved surface and align the wheels straight ahead.
Remove the horn button assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>REMOVAL
Connect the cable to the negative (-) auxiliary battery terminal.
for M15A-FXE: Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>INSTALLATION
for M15A-FKS: Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>INSTALLATION
for 1KR-FE: Click hereGeneral>MAINTENANCE>1KR-FE AUXILIARY BATTERY>INSTALLATION
Using a torque wrench, check that the steering wheel set bolt is properly tightened.
Turn the power switch on (READY) so that the power steering is ready to operate. (for HV Model)
Start the engine so that the power steering is ready to operate. (for Gasoline Model)
Turn the steering wheel 90 degrees to the right and check steering effort (torque) with the steering wheel turned. Check in the opposite direction using the same method.
5.5 N*m (56 kgf*cm, 49 in.*lbf) or less
Align the front wheels facing straight ahead.
Turn the ignition switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal.
for M15A-FXE: Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
for M15A-FKS: Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for 1KR-FE: Click hereGeneral>MAINTENANCE>1KR-FE AUXILIARY BATTERY>INSTALLATION
Install the horn button assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>INSTALLATION