If air does not flow from the front registers after the blower switch on the air conditioning control assembly is operated, the following factors may be the cause.
| Symptom | Factor |
|---|---|
| Blower motor does not operate at all
(Air does not blow from registers) |
·
Harness or connector ·
Air conditioning amplifier assembly malfunction ·
Blower motor with fan sub-assembly malfunction ·
Warm-up control ·
Engine coolant temperature sensor malfunction |
Turn off the AUTO switch, operate the blower switch and check that the blower motor with fan sub-assembly can be operated manually.
The blower motor with fan sub-assembly operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Coolant Temperature | Engine coolant temperature | Min.: -40°C (-40°F), Max.: 140°C (284°F) | 75 to 100°C (167 to 212°F): After warming up | This is the engine coolant temperature.
|
| Tester Display |
|---|
| Coolant Temperature |
After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.
| Result | Proceed to |
|---|---|
| OK (except G16E-GTS) | A |
| OK (for G16E-GTS) | B |
| NG (for 1KR-FE) | C |
| NG (for M15A-FKS) | D |
| NG (for G16E-GTS) | E |
A
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER (except G16E-GTS)>REMOVAL
B
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER (for G16E-GTS)>REMOVAL
C
D
E