The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
16681A
2.REMOVE RADIATOR UPPER AIR GUIDE PLATE
53875A
3.REMOVE FRONT FENDER LINER RH
53510
4.REMOVE HOOD LOCK ASSEMBLY
w/ Engine Hood Courtesy Switch:
| *a | Clamp |
| *b | guide |
Disconnect the connector.
Disengage the clamp and guide.
Remove the 3 bolts.
Disengage the guide to disconnect the hood lock control cable assembly, and remove the hood lock assembly.
55606
5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
53601
6.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
53601
7.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Disengage the guide.
Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly.
53630
8.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
Disconnect the hood lock control cable assembly from the clamps.
| *a | Grommet | - | - |
Disengage the grommet.
Pull the hood lock control cable assembly from the engine compartment to remove it.