Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB (for TMC Made G16E-GTS) › from 2020.09
RM36W0E _52 Drivetrain _087260 AXLE AND DIFFERENTIAL _0447528 REAR AXLE HUB(for TMC Made G16E-GTS) A

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for TMC Made G16E-GTS)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.
C445882C01
2.417,1.74 2.417,0.792 2.417,0.792 2.719,0.792 true 2.417,1.073 2.844,1.073 true 2.344,1.76 2.635,1.969 0.292,0.208 10 false *a
*a Matchmark


Align the matchmarks on the rear drive shaft assembly and rear axle hub and bearing assembly.

NOTICE:

Be careful not to damage the thread portion of the rear drive shaft assembly.



b.

Install the rear axle hub and bearing assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)

NOTICE:

Be careful not to damage the drive shaft boot.



Hide 42312B 4.TEMPORARILY TIGHTEN REAR AXLE SHAFT NUT

a.

Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using non-residue solvent.

NOTICE:
·

Be sure to perform this work even when using a new rear drive shaft assembly.

·

Keep the threaded parts free of oil and foreign matter.




b.

Using a 30 mm socket wrench, install the rear axle shaft nut.

Torque:
216 N*m (2203 kgf*cm, 159 ft.*lbf)

NOTICE:

Stake the rear axle shaft nut after inspecting for looseness and runout in the following steps.


HINT:

Depress the brake pedal to prevent the drive shaft from rotating.



Hide 10.ADJUST PARKING BRAKE SHOE CLEARANCE

Hide 42491 11.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 13.STAKE REAR AXLE SHAFT NUT

a.
C445879

Using a chisel and hammer, stake the rear axle shaft nut.


Hide 14.CONNECT REAR SPEED SENSOR

a.

Install the rear speed sensor to the rear axle carrier sub-assembly with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Keep the tip of the rear speed sensor and installation hole free of foreign matter.

·

Firmly insert the rear speed sensor body into the rear axle carrier before tightening the bolt.

·

After installing the rear speed sensor to the rear axle carrier, make sure that there is no clearance between the rear speed sensor stay and rear axle carrier. Also make sure that no foreign matter is stuck between the parts.




Hide 15.INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL

Hide 16.INSTALL REAR WHEEL