Home › Suspension › REAR SUSPENSION › REAR LOWER ARM › from 2020.09
RM36W0E _53 Suspension _087264 REAR SUSPENSION _0447925 REAR LOWER ARM A

REAR SUSPENSION  REAR LOWER ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 48720A 1.TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY

a.

Temporarily install the rear No. 1 suspension arm assembly to the rear axle carrier sub-assembly and rear suspension member sub-assembly with the 2 bolts and 2 nuts.

NOTICE:
·

Tighten the bolt with the nut secured.

·

Insert the bolt with the threaded end facing the front of the vehicle.




Hide 48740F 2.TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY

a.

Temporarily install the rear No. 2 suspension arm assembly to the rear suspension member sub-assembly with the No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and nut.

NOTICE:
·

Insert the rear suspension toe adjust cam sub-assembly from the front of the vehicle.

·

When tightening the nut, keep the rear suspension toe adjust cam sub-assembly from rotating.




Hide 48258C 3.INSTALL REAR LOWER COIL SPRING INSULATOR

Hide 48840A 6.INSTALL REAR STABILIZER LINK ASSEMBLY

Hide 48720A 7.FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY

a.
C445836

Install the rear No. 1 suspension arm assembly with the 2 bolts.

Torque:
73 N*m (744 kgf*cm, 54 ft.*lbf)

NOTICE:

Tighten the bolt with the nut secured.



Hide 48740F 8.FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY

a.
C445829

Install the rear No. 2 suspension arm assembly (rear axle carrier sub-assembly side) with the bolt.

Torque:
73 N*m (744 kgf*cm, 54 ft.*lbf)

NOTICE:

Tighten the bolt with the nut secured.



Hide 9.INSTALL REAR WHEEL

Hide 48740F 10.FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY

a.

Lower the vehicle to the ground.


b.

Bounce the vehicle up and down at the corners to stabilize the rear suspension.


c.
C445837C01
2.573,1.448 2.802,1.448 true 2.573,1.833 2.573,1.396 2.573,1.396 2.792,1.396 true 1.365,0.844 1.365,0.542 1.365,0.542 1.135,0.542 true 1.125,0.604 1.354,0.604 true 2.479,1.802 2.708,1.99 0.229,0.188 10 true *a 1.26,0.875 1.49,1.063 0.229,0.188 10 true *a
*a Matchmark


Align the matchmarks on the No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and rear suspension member sub-assembly.


d.

Fully tighten the nut.

Torque:
100 N*m (1020 kgf*cm, 74 ft.*lbf)

NOTICE:
·

Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.

·

Make sure that the vehicle is unloaded when fully tightening the nut.