Home › Engine / Hybrid System › G16E-GTS (FUEL) › FUEL TANK › from 2020.09
RM36W0E _51 Engine / Hybrid System _095688 G16E-GTS FUEL _0449366 FUEL TANK A

G16E-GTS FUEL  FUEL TANK  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Gas leaks from exhaust system is repaired Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.


·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

·
A344817

The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.



NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1.DRAIN FUEL

Hide 77020A 2.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Hide 58325E 3.REMOVE REAR FLOOR SERVICE HOLE COVER (for RH Side)

Hide 77285D 4.REMOVE NO. 1 FUEL TUBE CLAMP

Hide 77144 5.REMOVE FUEL PUMP GAUGE RETAINER

Hide 77010 6.REMOVE FUEL TANK VENT TUBE ASSEMBLY

Hide 7.REMOVE DIFFERENTIAL CARRIER ASSEMBLY

Hide 77642A 8.REMOVE NO. 2 FUEL TANK PROTECTOR

a.
A472024

Remove the nut, 4 clips and No. 2 fuel tank protector.


Hide 77606 9.REMOVE NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY

a.
A472025

Remove the 4 clips and No. 1 fuel tank protector sub-assembly.


Hide 77026A 10.REMOVE NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY

a.
A472026

Remove the No. 1 fuel evaporation tube sub-assembly from the fuel pipe.

Click hereEngine / Hybrid System>G16E-GTS (FUEL)>FUEL SYSTEM>PRECAUTION


Hide 77209F 11.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY

a.
A472027

Remove the fuel tank main tube sub-assembly from the fuel pipe.

Click hereEngine / Hybrid System>G16E-GTS (FUEL)>FUEL SYSTEM>PRECAUTION


Hide 77213E 12.DISCONNECT FUEL TANK TO FILLER PIPE HOSE

a.
A472028

Loosen the hose clamp to disconnect the fuel tank to filler pipe hose from the fuel tank assembly.


Hide 13.DISCONNECT FUEL TANK FILLER PIPE SUB-ASSEMBLY

a.
A472029

Disconnect the fuel tank filler pipe sub-assembly.


Hide 77226A 14.DISCONNECT NO. 6 FUEL TANK BREATHER TUBE

a.
A472030

Disconnect the No. 6 fuel tank breather tube.


Hide 77100U 15.REMOVE FUEL TANK ASSEMBLY

CAUTION:
A344817

The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.


a.
A472032

Support the fuel tank assembly using an engine lifter.

HINT:

Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.



b.

Remove the 4 bolts and 2 fuel tank band sub-assemblies.


c.
A472031

Lower the engine lifter to remove the fuel tank assembly.

NOTICE:
·

Be careful not to drop the fuel tank assembly.

·

When removing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.




Hide 77754B 16.REMOVE CHARCOAL CANISTER OUTLET HOSE

a.
A472033

Disengage the clamp to remove the charcoal canister outlet hose from the fuel tank assembly.