This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
23250F
1.INSTALL PORT FUEL INJECTOR ASSEMBLY
Perform "Inspection After Repair" after replacing a fuel injector assembly.
Click hereEngine / Hybrid System>G16E-GTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
Apply a light coat of spindle oil or gasoline to 3 new O-rings, and install one to each fuel injector assembly.
Check that there is no damage or foreign matter on the groove of the fuel injector assembly when installing the O-ring to each fuel injector assembly.
| *a | Claw |
| *b | Stopper |
Install the 3 fuel injector assemblies to the fuel delivery pipe.
Make sure that the fuel injector assembly is located within the stopper as shown in the illustration.
Check that the fuel injector assembly installation holes of the fuel delivery pipe are not damaged and are free of foreign matter.
Make sure that the O-ring is not damaged, twisted or moved out of place when installing the fuel injector assembly.
82125N
2.INSTALL NO. 5 ENGINE WIRE
Engage the 2 clamps to install the No. 5 engine wire to the fuel delivery pipe.
Connect the 4 connectors to the 3 fuel injector assemblies and fuel pressure sensor.
23291A
3.INSTALL INJECTOR VIBRATION INSULATOR
Install 3 new injector vibration insulators to the cylinder head sub-assembly.
23891
4.INSTALL FUEL DELIVERY SPACER
Install the 2 fuel delivery spacers to the cylinder head sub-assembly.
23814B
5.INSTALL FUEL DELIVERY PIPE
Place the fuel delivery pipe with the 3 fuel injector assemblies onto the cylinder head sub-assembly.
Be careful not to drop the fuel injector assemblies when installing the fuel delivery pipe.
Install the fuel delivery pipe with the fuel injector assemblies with the 2 bolts.
23825
6.INSTALL FUEL DELIVERY GUARD
Temporarily install the fuel delivery guard.
Install the 2 bolts and 2 nuts in the order shown in the illustration.
Engage the engine wire clamp.
11452D
7.INSTALL OIL LEVEL GAUGE GUIDE
Apply a light coat of engine oil to a new O-ring.
Install the O-ring to the engine oil level guide.
Install the engine oil level guide with the bolt.
15301B
8.INSTALL OIL LEVEL GAUGE SUB-ASSEMBLY
Install the engine oil level gauge sub-assembly.
16288
9.INSTALL NO. 4 WATER BY-PASS PIPE
Install the No. 4 water by-pass pipe to the cylinder head sub-assembly with the 3 bolts.
23902
10.CONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY
Connect the No. 2 fuel tube sub-assembly to the fuel delivery pipe.
Click hereEngine / Hybrid System>G16E-GTS (FUEL)>FUEL SYSTEM>PRECAUTION
23841K
11.INSTALL FUEL PIPE CLAMP
Install the fuel pipe clamp to the fuel tube connector.
82121
12.INSTALL ENGINE WIRE
12601B
13.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
14.INSPECT FOR FUEL LEAK
15.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing a fuel injector assembly.
Click hereEngine / Hybrid System>G16E-GTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION