This DTC is output when an open circuit or short occurs in the communication line between a rear center ultrasonic sensor (RLC sensor) and the rear corner ultrasonic sensor (RL sensor), or when a malfunction occurs in a rear center ultrasonic sensor (RLC sensor) on the rear.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE787 | Ultrasonic Sensor (Rear Left Center) Missing Message | Rear center ultrasonic sensor (RLC sensor) lost communication | ·
Rear center ultrasonic sensor (RLC sensor) ·
Harness or connector ·
Clearance warning ECU assembly |
Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
If a DTC is detected again after the repair, turn the ignition switch to ON and turn the TOYOTA parking assist-sensor system on, and then clear the DTC.
If C1AE696 is output at the same time, check C1AE696 first.
Initialize the rear corner ultrasonic sensors (RL and RR sensors) and rear center ultrasonic sensors (RLC and RRC sensors).
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Symptoms | DTC Detection | |||
|---|---|---|---|---|
| C1AE687 | C1AE787 | C1AE887 | C1AE987 | |
| Symptom 1 | Not output | Not output | Not output | Not output |
| Symptom 2 | Not output | Not output | Not output | Output |
| Symptom 3 | Not output | Not output | Output | Output |
| Symptom 4 | Not output | Output | Output | Output |
| Symptom 5 | Output | Output | Output | Output |
| Result | Proceed to |
|---|---|
| Listed under symptom 1 in combination table | A |
| Listed under symptom 2 in combination table | B |
| Listed under symptom 3 in combination table | C |
| Listed under symptom 4 in combination table | D |
| Listed under symptom 5 in combination table | E |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
D
E
Disconnect the W1 rear corner ultrasonic sensor (RL sensor) connector.
Disconnect the W2 rear center ultrasonic sensor (RLC sensor) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| W1-1 (BO) - W2-4 (BI) | Always | Below 1 Ω |
| W1-2 (SO) - W2-5 (SI) | Always | Below 1 Ω |
| W1-3 (EO) - W2-6 (EI) | Always | Below 1 Ω |
| W1-1 (BO) or W2-4 (BI) - Body ground | Always | 10 kΩ or higher |
| W1-2 (SO) or W2-5 (SI) - Body ground | Always | 10 kΩ or higher |
| W1-3 (EO) or W2-6 (EI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the rear center ultrasonic sensor (RLC sensor) with a known good one.
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC C1AE787 is output | B |
A
B