This DTC is output when an open circuit or short occurs in the communication line between a rear corner ultrasonic sensor (RR sensor) and the rear center ultrasonic sensor (RRC sensor), or when a malfunction occurs in a rear corner ultrasonic sensor (RR sensor) on the rear.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE987 | Ultrasonic Sensor (Rear Right Corner) Missing Message | Rear corner ultrasonic sensor (RR sensor) lost communication | ·
Rear corner ultrasonic sensor (RR sensor) ·
Harness or connector ·
Clearance warning ECU assembly |
Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
If a DTC is detected again after the repair, turn the ignition switch to ON and turn the TOYOTA parking assist-sensor system on, and then clear the DTC.
If C1AE896 is output at the same time, check C1AE896 first.
Initialize the rear corner ultrasonic sensors (RL and RR sensors) and rear center ultrasonic sensors (RLC and RRC sensors).
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Symptoms | DTC Detection | |||
|---|---|---|---|---|
| C1AE687 | C1AE787 | C1AE887 | C1AE987 | |
| Symptom 1 | Not output | Not output | Not output | Not output |
| Symptom 2 | Not output | Not output | Not output | Output |
| Symptom 3 | Not output | Not output | Output | Output |
| Symptom 4 | Not output | Output | Output | Output |
| Symptom 5 | Output | Output | Output | Output |
| Result | Proceed to |
|---|---|
| Listed under symptom 1 in combination table | A |
| Listed under symptom 2 in combination table | B |
| Listed under symptom 3 in combination table | C |
| Listed under symptom 4 in combination table | D |
| Listed under symptom 5 in combination table | E |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
D
E
Disconnect the W3 rear center ultrasonic sensor (RRC sensor) connector.
Disconnect the W4 rear corner ultrasonic sensor (RR sensor) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| W3-1 (BO) - W4-4 (BI) | Always | Below 1 Ω |
| W3-2 (SO) - W4-5 (SI) | Always | Below 1 Ω |
| W3-3 (EO) - W4-6 (EI) | Always | Below 1 Ω |
| W3-1 (BO) or W4-4 (BI) - Body ground | Always | 10 kΩ or higher |
| W3-2 (SO) or W4-5 (SI) - Body ground | Always | 10 kΩ or higher |
| W3-3 (EO) or W4-6 (EI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the rear corner ultrasonic sensor (RR sensor) with a known good one.
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC C1AE987 is output | B |
A
B