Home › Drivetrain › EA67F (MANUAL TRANSMISSION / TRANSAXLE) › TRANSMISSION CONTROL CABLE › from 2020.09
RM36W0E _52 Drivetrain _095283 EA67F MANUAL TRANSMISSION / TRANSAXLE _0449593 TRANSMISSION CONTROL CABLE N

EA67F MANUAL TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  ADJUSTMENT  


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
·
C332327

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to neutral, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 58910C 2.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 33820B 4.ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY

HINT:
·

After the floor shift shift lever assembly or the transmission control cable assembly is replaced, be sure to adjust the transmission control cable assembly.

·

If the shift lever does not move (or the shift lever is difficult to move) to the 1st or 2nd position, or if it is possible to move the shift lever to the reverse position without pulling up the slider shaft, the length of the transmission control cable assembly must be adjusted.



a.
C432076

Remove the clip and disconnect the transmission control select cable from the floor shift shift lever assembly.


b.
C405382C03
1.792,1.76 1.865,1.583 1.865,1.583 2.094,1.583 false 0.885,2.427 1.083,2.427 1.083,2.427 1.177,2.583 false 2.125,1.479 2.438,1.635 0.313,0.156 10 false *a 0.729,2.333 1.042,2.49 0.313,0.156 10 false *b 1.458,1.406 1.771,1.563 0.313,0.156 10 false *c 0.854,0.844 1.167,1 0.313,0.156 10 false *d 1.698,0.979 2.01,1.135 0.313,0.156 10 false *c 1.365,2.375 1.677,2.531 0.313,0.156 10 false *d
*a Slider
*b Lock Piece
*c Slide
*d Pull


Slide the slider of the transmission control select cable in the direction indicated by the arrow in the illustration and pull the lock piece outward.


c.
C401634C02
1.302,1.24 1.521,1.052 true 1.156,1.219 1.333,1.375 0.177,0.156 10 true *a
*a Lock Piece


Connect the transmission control select cable to the floor shift lever assembly and install the clip.

NOTICE:
·

Check that the lock piece is pulled out.

·

Push the end of the transmission control select cable all the way to the base of the floor shift shift lever assembly pin.

·

Connect the transmission control select cable so that the lock piece faces the driver side.




d.
C439981C01
1.583,0.146 1.781,0.344 0.198,0.198 10 true *a 1.677,0.854 1.875,1.063 0.198,0.208 10 true *b 1.698,1.552 1.917,1.76 0.219,0.208 10 true *c
*a Press
*b Press and Hold
*c Push in the shift and select lever pin


Pressing the shift and select lever shaft and shift and select lever pin, push in the shift and select lever pin and check that the shift and select lever shaft is secured at the 1st-2nd gear (the shaft comes to a stop at the position 8 mm (0.315 in.) below the N position).


e.
C432097C02
0.698,2.073 0.833,2.219 true 0.5,2.302 0.656,2.427 true 0.5,1.948 0.667,2.125 0.167,0.177 10 true *a 0.323,2.219 0.51,2.396 0.188,0.177 10 true *b
*a Slider Shaft
*b Cam Wall


Push the slider shaft against the cam wall.

NOTICE:
·

Do not pull up the slider shaft.

·

When adjusting the transmission control select cable, make sure that the shift lever is not in 1st or 2nd.




f.
C329174C02
0.99,0.479 1.125,0.479 1.125,0.479 1.26,0.99 false 1.99,0.302 1.854,0.302 1.854,0.302 1.76,0.76 false 2.052,0.208 2.313,0.417 0.26,0.208 10 false *a 0.813,0.396 1.104,0.594 0.292,0.198 10 false *b 1.698,2.979 2.01,3.135 0.313,0.156 10 false *c
*a Lock Piece
*b Adjuster Case
*c Push in


Push the lock piece into the adjuster case.

NOTICE:
·

Securely push in the lock piece until the 2 claws are engaged.

·

When adjusting the transmission control select cable, make sure that the shift lever is not in 1st or 2nd.




g.
C450659C01
1.792,1.458 1.99,1.646 0.198,0.188 10 true *a
*a Pull


Release the shift and select lever pin that secures the shift and select lever shaft.

i.

Pull the shift and select lever pin toward the front left side of the vehicle.



Hide 58910C 6.INSTALL REAR CONSOLE BOX ASSEMBLY