Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › ECM › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449781 ECM A

G16E-GTS ENGINE CONTROL  ECM  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

After performing the ECU configuration procedure and update ECU security key procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 89667E 1.INSTALL NO. 1 ECM BRACKET

a.

Install the No. 1 ECM bracket to the ECM with the screw.

Torque:
5.25 N*m (54 kgf*cm, 4 ft.*lbf)


Hide 89668 2.INSTALL NO. 2 ECM BRACKET

a.

Install the No. 2 ECM bracket to the ECM with the 2 screws.

Torque:
5.25 N*m (54 kgf*cm, 4 ft.*lbf)


Hide 89661 3.INSTALL ECM

a.

Install the bolt and nut.

Torque:
8.0 N*m (82 kgf*cm, 6 ft.*lbf)


b.

Engage the clamp.


c.

Connect the 3 ECM connectors and lower the 3 lock levers.

NOTICE:
·

When connecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

·

Be sure to securely connect the ECM connectors.




Hide 4.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 17881 5.INSTALL NO. 1 AIR CLEANER HOSE

Hide 17751 6.INSTALL NO. 1 AIR CLEANER INLET

Hide 7.CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 8. ECU CONFIGURATION

a.

If the ECM has been replaced, perform ECU configuration.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>ECU CONFIGURATION


Hide 10. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART