Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL MOUNT CUSHION › from 2020.09
RM36W0E _52 Drivetrain _087260 AXLE AND DIFFERENTIAL _0447537 DIFFERENTIAL MOUNT CUSHION A

AXLE AND DIFFERENTIAL  DIFFERENTIAL MOUNT CUSHION  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear No. 1 differential mount cushion replacement are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leaks from exhaust system Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Tire ECU Data Initialization (When performing tire replacement after RoB code X2104 is output) Active torque split AWD system (Click here)
Suspension, tires, etc. Rear television camera assembly optical axis (Back camera position setting) Parking assist monitor system (Click here)
Rear wheel alignment adjustment Calibration
·

DTCs are stored

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)

CAUTION:
·
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

·
A346363C01
2.219,0.813 2.646,0.813 false 2.698,0.729 3.01,0.927 0.313,0.198 10 false *a
*a An Object Exceeding Weight Limit of Engine Lifter


The rear differential carrier assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the rear differential carrier assembly may fall off the engine lifter.



PROCEDURE

Hide 41110 1.REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

Hide 41651 2.REMOVE REAR NO. 1 DIFFERENTIAL MOUNT CUSHION

a.

Using SST, remove the rear No. 1 differential mount cushion.

SST
09316-20011  
09570-24011  

C450356C01
5.802,0.51 5.802,0.344 5.802,0.344 6.469,0.344 false 6.344,0.677 6.344,0.344 false 6.25,0.635 6.25,0.344 false 6.438,1.625 6.198,1.5 false 4.323,2.469 4.573,2.719 0.25,0.25 10 false *a 3.031,2.729 3.281,2.979 0.25,0.25 10 false *b 6.5,0.271 6.917,0.521 0.417,0.25 10 false SST 6.479,1.563 6.729,1.813 0.25,0.25 10 false *1
*1 Rear Suspension Member Sub-assembly - -
*a Turn *b Hold
V100135

Turning Direction
V100136

Front of Vehicle
V100137

SST Bolt Position - -


NOTICE:
·

Do not bring SST into contact with the rear suspension member sub-assembly.

·

Before using SST, apply grease to SST bolt.

·

Set SST in the correct direction.

·

Do not tilt the bolt of SST.

·

Do not reuse the rear No. 1 differential mount cushion.