Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › KNOCK SENSOR › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449864 KNOCK SENSOR A

G16E-GTS ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Air leaks from intake system

·

Replacement of knock control sensor


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION / NOTICE / HINT

PROCEDURE

Hide 16281 2.REMOVE NO. 4 WATER BY-PASS HOSE

a.
A481039

Slide the 2 clips and remove the No. 4 water by-pass hose.


Hide 16283 3.DISCONNECT NO. 6 WATER BY-PASS HOSE

a.
A481044

Slide the clip and disconnect the No. 6 water by-pass hose.


Hide 12582D 5.REMOVE NO. 2 CYLINDER BLOCK INSULATOR

Hide 89615 7.REMOVE KNOCK SENSOR

a.
A480401

Disconnect the knock sensor connector.


b.

Remove the bolt and knock sensor from the cylinder block sub-assembly.

NOTICE:

If the knock sensor has been struck or dropped, replace it.