Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 1) › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449865 AIR FUEL RATIO SENSOR(for Sensor 1) A

G16E-GTS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
·

Replacement of air fuel ratio sensor (sensor 1)

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A344783

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust manifold.

·

Touching high-temperature areas such as the engine and exhaust manifold could result in burns.



PROCEDURE

Hide 1.REMOVE WINDSHIELD WIPER MOTOR AND LINK

Hide 55815E 2.REMOVE FRONT NO. 1 VENTILATOR SEAL (for LHD)

Hide 55815E 3.REMOVE FRONT NO. 1 VENTILATOR SEAL (for RHD)

Hide 55734A 4.REMOVE WATER GUARD PLATE RH (for LHD)

Hide 55735A 5.REMOVE WATER GUARD PLATE LH (for RHD)

Hide 55701J 6.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 55701J 7.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Hide 17881 8.SEPARATE NO. 1 AIR CLEANER HOSE

Hide 17893 9.REMOVE INTAKE AIR RESONATOR

Hide 89467B 10.REMOVE AIR FUEL RATIO SENSOR

a.
A480403N01
1.24,1.344 0.552,1.031 true 0.104,0.917 0.563,1.115 0.458,0.198 10 true SST

Disconnect the air fuel ratio sensor connector.


b.

Disengage the 2 clamps.


c.

Using SST, remove the air fuel ratio sensor from the exhaust manifold.

SST
09224-00012  

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.