Home › Engine / Hybrid System › STOP AND START › BACKUP BOOST CONVERTER › from 2020.09
RM36W0E _51 Engine / Hybrid System _090986 STOP AND START _0431195 BACKUP BOOST CONVERTER A

STOP AND START  BACKUP BOOST CONVERTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the engine stop and start ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 3.REMOVE FRONT BUMPER ASSEMBLY (for 5 Door)

Hide 4.REMOVE FRONT BUMPER ASSEMBLY (for 3 Door)

Hide G92C0A 5.REMOVE ECO RUN VEHICLE CONVERTER ASSEMBLY

a.
A468067C01
1.042,0.615 0.76,0.406 false 2.76,0.917 2.854,0.813 false 2.865,0.708 3.177,0.906 0.313,0.198 10 false *a 0.594,0.292 0.906,0.49 0.313,0.198 10 false *a
*a Lock Lever


Move the lock lever as shown in the illustration and disconnect the eco run vehicle converter assembly connector.


b.
A468068

Remove the bolt, nut and eco run vehicle converter assembly.


Hide F1334 6.REMOVE NO. 1 CONVERTER CONTROL BRACKET

a.
A468069

Remove the 2 bolts and No. 1 converter control bracket from the eco run vehicle converter assembly.