Check that the antenna cord sub-assembly cable is properly installed and does not have any sharp bends, pinching or loose connections before performing following procedure.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Clear the fault list.
| Proceed to |
|---|
| NEXT |
NEXT
Check for color of status indicators.
| Result | Proceed to |
|---|---|
| GPS antenna indicator is red | A |
| GPS antenna indicator is green or gray | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Remove the antenna cord sub-assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL
| *a | Component without harness connected
(Antenna Cord Sub-assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| GS-3 - GP-1 | Always | Below 1 Ω |
| GS-3a - GP-1a | Always | Below 1 Ω |
| GS-3 or GP-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the navigation antenna assembly.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION ANTENNA>REMOVAL
| *a | Component without harness connected
(Navigation Antenna Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 3a | Always | 50 to 500 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG