Skid Control Buzzer Circuit
Circuit diagnosis · Vehicles built from Aug 2005
DESCRIPTION
The skid control buzzer sounds while the VSC is activated.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if the CAN communication DTC is output (Click here).
Result
Proceed to
DTC not output
A
DTC output
B
|
|
||||
| A | |
| 2. PERFORM ACTIVE TEST BY INTELLIGENT TESTER (SKID CONTROL BUZZER) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the tester on.
Select the ACTIVE TEST mode on the intelligent tester.
ACTIVE TEST: ABS/VSC/TRC Item (Display)
Test Details
Diagnostic Note
Buzzer
Turns skid control buzzer ON / OFF
Buzzer can be heard
Check that the buzzer sounds and stops sounding when the skid control buzzer is turned on and off using the intelligent tester.
- OK:
- The skid control buzzer sounds and stops sounding in accordance with the intelligent tester operation.
|
|
||||
| OK | ||
| ||
| 3. INSPECT COMBINATION METER |
Inspect the combination meter (Click here).
|
|
||||
| OK | ||
| ||
