2005-2008 Yaris · Service Manual ENGINE

P0261 Cylinder 1 Injector Circuit Low

Diagnostic trouble codes · Vehicles built from Aug 2005

Also covers:

DESCRIPTION

The injectors are installed in the intake manifold, and inject fuel into the cylinders based on the signals from the ECM.
DTC No.
DTC Detection Condition
Trouble Area
P0261
P0264
P0267
Open or short to GND in injector circuit (3 trip detection logic)
  1. Open or short to GND in injector circuit
  2. Injector
  3. ECM
P0262
P0265
P0268
Short in power source circuit (3 trip detection logic)
  1. Short in injector power source circuit
  2. Injector
  3. ECM

HINT:
  1. These DTCs are detected when the engine idles for approximately 15 seconds.
  2. If DTC P0261 or P0262 is displayed, check No.1 injector circuit.
  3. If DTC P0264 or P0265 is displayed, check No.2 injector circuit.
  4. If DTC P0267 or P0268 is displayed, check No.3 injector circuit.


WIRING DIAGRAM

A109128E01

INSPECTION PROCEDURE

NOTICE:
Perform electronic throttle learning after replacing the ECM (Click here).

HINT:
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.


1. CHECK HARNESS AND CONNECTOR (ECM - FUEL INJECTOR)
A120340E01
  1. Disconnect the fuel injector connectors.

  1. Disconnect the ECM connector.

  1. Check the resistance.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    #1 (C33-43) - Injector (C4-1)
    Below 1 Ω
    #2 (C33-42) - Injector (C5-1)
    Below 1 Ω
    #3 (C33-44) - Injector (C6-1)
    Below 1 Ω

    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    #1 (C33-43) or Injector (C4-1) - Body ground
    10 kΩ or higher
    #2 (C33-42) or Injector (C5-1) - Body ground
    10 kΩ or higher
    #3 (C33-44) or Injector (C6-1) - Body ground
    10 kΩ or higher

  1. Reconnect the fuel injector connectors.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT FUEL INJECTOR (RESISTANCE)
  1. Disconnect the fuel injector connector.

  1. Measure the resistance between the injector terminals.

    Standard:
    11.6 to 12.4 Ω at 20°C (68°F)

  1. Reconnect the fuel injector connector.



NG
REPLACE FUEL INJECTOR
OK

REPLACE ECM


← P0171 System Too Lean (Bank 1) (+ P0172) (from Aug 2005)P0300 Random / Multiple Cylinder Misfire Detected (+ P0301, P0302, P0303) (from Aug 2005) →