2005-2008 Yaris · Service Manual SECURITIES

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2005

HINT:
  1. Use these procedures to troubleshoot the engine immobiliser system.
  1. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CRANK ENGINE FOR MORE THAN 10 SECONDS
      NEXT

      3.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
      1. Using the intelligent tester, check if the LIN Communication System is functioning normally (Click here).

        Result: 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      A

      4.CHECK FOR DTC*
      1. Check for DTCs and note down any codes that are output (Click here).

      2. Clear the DTC.

      3. Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same SFI system DTC or engine immobiliser system DTC by simulating the symptoms indicated by the DTC.

      4. Result
        Proceed to
        DTC output does not recur
        A
        SFI system (1KR-FE) DTC output recurs
        B
        SFI system (2SZ-FE) DTC output recurs
        C
        SFI system (2ZR-FE) DTC output recurs
        D
        ECD system (1ND-TV) DTC output recurs
        E
        Engine immobiliser system DTC output recurs
        F

      B.

      C.

      D.

      E.

      F.
      A

      5.PROBLEM SYMPTOMS TABLE
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B

      B.
      A

      6.OVERALL ANALYSIS AND TROUBLESHOOTING*
      1. Data List/Active Test (Click here)

      2. Terminals of ECU (Click here)

      NEXT

      7.ADJUST, REPAIR OR REPLACE
        NEXT

        8.CONFIRMATION TEST
          NEXT

          ← SYSTEM DESCRIPTION (from Aug 2005)PROBLEM SYMPTOMS TABLE (Aug 2005 – Oct 2005) →