2005-2008 Yaris · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2005

HINT:
  1. Use these procedures to troubleshoot the entry and start system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
    1. Using the intelligent tester, check if the LIN communication system is functioning normally.

      Result:
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B


    B.
    A

    4.PROBLEM SYMPTOMS TABLE

      Result:
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. On-vehicle Inspection (Click here)

    2. Data List / Active test

    3. Terminals of ECU

    4. Inspection

    NEXT

    6.ADJUST, REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Aug 2005)CUSTOMIZE PARAMETERS (from Aug 2005) →