2005-2008 Yaris · Service Manual TRANSMISSION

PRECAUTION

Precautions · Vehicles built from Nov 2005


1.When racing the engine, make sure that the gear is in neutral.

2.If the multi-mode manual transmission system stops with the transmission set in any gear, the vehicle can be moved by disconnecting the shift & select actuator plug and setting the transmission to neutral.

3.When replacing the following parts, proceed with the operation according to the order listed in the table below.
Before removal 
Parts to be removed
Operation order
See procedure
  1. Clutch actuator
  2. Transmission assembly
  3. Transmission parts (inside gear box)
  4. Clutch disc and clutch cover
  5. Clutch release bearing
  6. Clutch release fork
  7. Clutch release lever
  8. Flywheel
  9. End plate (2SZ-FE only)
  10. Crankshaft
  11. Shift and select actuator (with clutch actuator)
  1. CLAMP POSITION ADJUSTMENT
(Click here)
Before installation 
Parts to be removed
Operation order
See procedure
  1. New clutch actuator
  1. CLAMP POSITION ADJUSTMENT
(Click here)

NOTICE:
Push rods of brand new clutch actuator (service supply parts) are not set to the clutch clamp position. Therefore, adjust the clamp positions before installing new clutch actuators.

After installation 
Parts to be removed
Operation order
See procedure
  1. Transmission assembly
  2. Transmission parts (inside gear box)
  3. Shift and select actuator (with clutch actuator)
  4. Transmission control ECU
1.INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
[Initialization of ECU]
(Click here)
2. LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
(Click here)
3. SYNCHRONIZATION POSITION CALIBRATION
(Click here)
  1. Shift stroke sensor
  2. Select stroke sensor
1.INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
[Initialization of transmission]
(Click here)
2. LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
(Click here)
3. SYNCHRONIZATION POSITION CALIBRATION
(Click here)
  1. Clutch actuator
  2. Clutch stroke sensor
  3. Clutch disc and clutch cover
  4. Clutch release bearing
  5. Clutch release fork
  6. Clutch release lever
  7. Flywheel
  8. End plate (2SZ-FE only)
  9. Crankshaft
1. INITIALIZATION OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
[Initialization of clutch]
(Click here)
2. LEARNING OF MULTI-MODE MANUAL TRANSMISSION SYSTEM
(Click here)

NOTICE:
  1. Always replace the clutch cover and the clutch disc together. If either is replaced without the other, the adjustment system of the clutch cover does not function properly. It may cause clutch drag or clutch slippage, which can result in deterioration of driveability or a defect in the system parts.
  2. Before proceeding with learning of the multi-mode manual transmission system, be sure to clear the previously stored learning values.

← PROBLEM SYMPTOMS TABLE (from Aug 2005)PROBLEM SYMPTOMS TABLE (from Nov 2005) →