2005-2008 Yaris · Service Manual ENGINE

P2109 Throttle / Pedal Position Sensor "A" Minimum Stop Performance

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
P2109
When any of the following is detected, electronic throttle learning value malfunction is detected: (1 trip detection logic)
  1. Sensor 1 fully-closed position learning value is 0.2 V or less
  2. Sensor 1 fully-closed position learning value is 0.2 V or more
  3. Sensor 2 fully-closed position learning value is 4.1 V or less
  4. Sensor 2 fully-closed position learning value is 4.8 V or more
Throttle body assembly
When the motor drive duty ratio for opening from the fully closed throttle valve is 35% or more during the electronic throttle system check. (1 trip detection logic)
When learning is not completed because the learning conditions are not satisfied. (1 trip detection logic)

HINT:
Detection for P2109 is performed during electronic throttle learning. (The learning can be performed using the tester)


WIRING DIAGRAM

A116149E01

INSPECTION PROCEDURE

NOTICE:
Perform electronic throttle learning after replacing the ECM (Click here).

HINT:
Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.


1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2109)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester ON.

  1. Enter the following menus: Power train / Engine / DTC .

  1. Read DTCs.

    Result:
    Display (DTC Output)
    Proceed To
    P2109
    A
    P2109 and P1127
    A
    P2109 and other DTCs (except P1127)
    B

    HINT:
    If any DTCs other than P2109 are output, troubleshoot those DTCs first.



B
GO TO DTC CHART
A


2. PERFORM ELECTRONIC THROTTLE LEARNING
  1. Perform the electronic throttle learning (Click here).

    OK:
    Learning is complete



OK
END
NG


3. CHECK WHETHER DTC OUTPUT RECURS (DTC P2109)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester ON.

  1. Enter the following menus: Power train / Engine / DTC .

  1. Read DTCs.

    Result:
    Display (DTC Output)
    Proceed to
    P2109
    A
    P2109 and other DTCs
    B

    HINT:
    If any DTCs other than P2109 are output, troubleshoot those DTCs first.



B
GO TO DTC CHART
A


Go to step 2

4. CHECK THROTTLE BODY ASSEMBLY (VISUALLY CHECK THROTTLE VALVE)
  1. Check for contamination between the throttle valve and the housing.

OK:
The throttle valve is not contaminated with foreign objects.



NG
CLEAN THROTTLE BODY ASSEMBLY
OK

REPLACE THROTTLE BODY ASSEMBLY


← P2101 Throttle Actuator Control Motor Circuit Range/Performance (+ P2102, P2103, P2111, P2118) (from Aug 2005)P2112 Throttle Actuator Control System - Stuck Closed (from Aug 2005) →