2005-2008 Yaris · Service Manual BRAKE

Brake Warning Light does not Come ON

Circuit diagnosis · Vehicles built from Aug 2005

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. PERFORM ACTIVE TEST BY INTELLIGENT TESTER (BRAKE WARNING LIGHT)

  1. A107926E08
    Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester on.

  1. Select the "Brake Warning Lamp" in the ACTIVE TEST and operate the BRAKE warning light using the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC / Active Test.

    ACTIVE TEST: ABS/VSC/TRC 
    Item (Display)
    Test Details
    Diagnostic Note
    Brake Warning Lamp
    Turns BRAKE warning light ON and OFF
    Observe combination meter

  1. Check that the BRAKE warning light turns on and off in the combination meter using the intelligent tester.

    OK:
    The BRAKE warning light turns ON and OFF in accordance with the intelligent tester operation.



OK
REPLACE ABS AND TRACTION ACTUATOR
NG


3. INSPECT COMBINATION METER
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR


← Brake Warning Light Remains ON (from Aug 2005)Slip Indicator Light Remains ON (from Aug 2005) →