2005-2008 Yaris · Service Manual BRAKE

Slip Indicator Light Remains ON

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

The SLIP indicator blinks during VSC and/or TRC operation.
When the system fails, the SLIP indicator comes on to warn the driver (Click here).

WIRING DIAGRAM

C120365E03
C117853E04

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).


1. INSPECT CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. CHECK SKID CONTROL ECU CONNECTOR
  1. Check if the skid control ECU connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


3. INSPECT COMBINATION METER
  1. Check the combination meter (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR


← Brake Warning Light does not Come ON (from Aug 2005)Slip Indicator Light does not Come ON (from Aug 2005) →