2005-2008 Yaris · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2006


CHECK FUEL PUMP OPERATION AND FUEL LEAK
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and the intelligent tester main switch ON.

    NOTICE:
    Do not start the engine.

  1. Select the following menu items: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump /Speed.

  1. Check that there is no fuel leakage anywhere in the fuel system after doing maintenance.


CHECK FUEL PRESSURE
  1. Discharge the fuel system pressure (Click here ).

  1. Using a voltmeter, measure the battery voltage.

    Standard voltage:
    11 to 14 V

  1. Disconnect the cable from the negative (-) battery terminal.

  1. Remove the fuel pipe clamp (Click here).

  1. Disconnect the fuel tube sub-assembly (Click here).

  1. A105669E04
    Install SST (pressure gauge and fuel tube connector) as shown in the illustration.
    SST
    09268-45014   (09268-41200, 09268-41220, 09268-41250)
    09268-41047   (90467-13001, 95336-08070, 09268-41500)

  1. Wipe off any spilt gasoline.

  1. Reconnect the cable to the negative (-) battery terminal.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and the intelligent tester main switch ON.

    NOTICE:
    Do not start the engine.

  1. Select the following menu items: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump /Speed.

  1. Measure the fuel pressure.

    Standard fuel pressure:
    304 to 343 kPa (3.1 to 3.5 kgf/cm2, 44.1 to 49.7 psi)

    If the pressure is high, replace the fuel pressure regulator.
    If the pressure is low, check the fuel hoses, fuel hose connections, fuel pump and fuel pressure regulator.

  1. Disconnect the intelligent tester from the DLC3.

  1. Start the engine.

  1. Measure the fuel pressure while the engine is idling.

    Standard fuel pressure:
    304 to 343 kPa (3.1 to 3.5 kgf/cm2, 44.1 to 49.7 psi)

    If the pressure is not as specified, check the vacuum sensing hose and the fuel pressure regulator.

  1. Stop the engine.

  1. Check that the fuel pressure remains as specified for 5 minutes after the engine stops.

    Standard fuel pressure:
    147 kPa (1.5 kgf/cm2, 21 psi) or more

    If the pressure is not as specified, check the fuel pump, pressure regulator and injectors.

  1. After checking the fuel pressure, disconnect the cable from the negative battery terminal and carefully remove SST to prevent gasoline splashes.

  1. Reconnect the fuel tube sub-assembly (Click here).

  1. Install the fuel pipe clamp (Click here).

  1. Inspect for fuel leak (Step 1).

← SYSTEM DIAGRAM (from Nov 2006)COMPONENTS (from Nov 2006) →