HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2005
- HINT:
- Use these procedures to troubleshoot the combination meter.
- Use the intelligent tester in steps 3 and 5.
- Use these procedures to troubleshoot the combination meter.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK CAN COMMUNICATION SYSTEM |
Use an intelligent tester to check if the CAN communication system is functioning normally.
- Result:
Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
|
|||||
| |||||
| 4.PROBLEM SYMPTOMS TABLE |
- Result:
Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 5.OVERALL ANALYSIS AND TROUBLESHOOTING |
Terminals of ECU (Click here )
Data List / Active Test (Click here )
On-vehicle Inspection (Click here )
| |||||
| 6.ADJUST, REPAIR OR REPLACE |
| |||||
| 7.CONFIRMATION TEST |
| |||||