2005-2008 Yaris · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Nov 2005

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the LHD. Use the same procedure for both RHD and LHD, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).


2. REMOVE FRONT SEAT HEADREST ASSEMBLY

  1. B124372E01
    Push in the lock button of the front seat headrest support and remove the front seat headrest.


3. REMOVE FRONT SEAT UNDER TRAY (w/ Under Tray)

  1. B126911
    Remove the front seat under tray.


4. REMOVE FRONT SEAT ASSEMBLY

HINT:
Use the same procedure as for the driver side (Click here).


5. REMOVE RECLINING ADJUSTER KNOB CAP

HINT:
Use the same procedure as for the driver side (Click here).


6. REMOVE RECLINING ADJUSTER RELEASE HANDLE

HINT:
Use the same procedure as for the driver side (Click here).


7. REMOVE FRONT SEAT CUSHION OUTER SHIELD

HINT:
Use the same procedure as for the driver side (Click here).


8. REMOVE FRONT SEAT INNER BELT ASSEMBLY

  1. B124386
    Disengage the claw and remove the buckle switch connector.

  1. Using a clip remover, remove the 2 clamps.

  1. Remove the wire harness from the claw of the front seat frame adjuster.

  1. Disconnect the occupant detection sensor connector.

  1. w/ Seat Heater System:

    1. Disconnect the seat heater connector.

  1. B134758
    Remove the bolt and the front seat inner belt.


9. REMOVE FRONT SEAT CUSHION INNER SHIELD

HINT:
Use the same procedure as for the driver side (Click here).


10. REMOVE FRONT SEAT CUSHION COVER PAD (Built in Occupant Detection Sensor)

  1. B134757
    Disengage the 7 hooks.

  1. B126905
    Disengage the claw and connector.

  1. Remove the 3 bands.

  1. Disengage the 2 hooks and remove the front seat cushion cover pad.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →