2005-2008 Yaris · Service Manual BRAKE

C1201/51 Engine Control System Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2005

DESCRIPTION

If a malfunction in the engine control system is detected, the operations of VSC and TRC are prohibited by the fail-safe function. When the signals from the engine are input normally, the fail-safe is cancelled and the DTC is not stored.
DTC No.
DTC Detecting Conditions
Trouble Areas
C1201/51
Engine control system malfunction signal continues for 5 seconds.
Engine control system

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION)
  1. Using an intelligent tester, check for any momentary interruption in the wire harness and connector corresponding to the DTC (Click here).

    Item
    Measurement Item / Range (Display)
    Normal Condition
    EFI COM OPN
    EFI communication open detection / ERROR or NORMAL
    ERROR: Momentary interruption
    NORMAL: Normal

    OK:
    There are no momentary interruptions.

    HINT:
    Perform the above inspection before removing the sensor and connector.



NG
Go to step 3
OK


2. CHECK ENGINE CONTROL SYSTEM
  1. Clear the DTC (engine control system).

  1. Check the DTC (engine control system).

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
Go to step 4
A

REPAIR ENGINE CONTROL SYSTEM

3. REPAIR OR REPLACE HARNESS OR CONNECTOR (ECM - SKID CONTROL ECU)

NEXT


4. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Perform a road test.

  1. Check if the same DTC is recorded (Click here).

    Result
    Proceed to
    DTC C1201/51 output
    A
    DTC not output
    B



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C0278/11 Open or Short Circuit in ABS Solenoid Relay Circuit (+ C0279/12) (from Aug 2005)C1203/53 ECM Communication Circuit Malfunction (from Aug 2005) →