P0191 Fuel Rail Pressure Sensor Circuit Range / Performance
Diagnostic trouble codes · Vehicles built from Nov 2005
DESCRIPTION
The ECM controls the internal fuel pressure of the common rail by using the supply pump and pressure control valve.| DTC No. |
DTC Detection Conditions |
Trouble Areas |
| P0191 |
After certain period of time has elapsed after engine stop (pressure control valve releases common rail internal pressure during this period), common rail internal pressure deviates from normal range. (Determination of a malfunction is conducted within a given time after the ignition switch is turned from on (IG) to off. If a malfunction is detected within this time, the MIL is illuminated and a DTC is set when the ignition switch is next turned to on (IG)) |
|
- HINT:
- DTC P0191 is set when the engine idles for 30 seconds after the ignition switch was turned to off.
WIRING DIAGRAM
Refer to DTC P0089 (Click here) and DTC P0190 (Click here).INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.
| 1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0191) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Read DTCs.
- Result:
Display (DTC Output)
Proceed To
P0191
A
P0191 and other DTCs
B
- HINT:
- If any DTCs other than P0191 are output, troubleshoot those DTCs first.
|
|
||||
| A | ||
| ||
