P0603 Internal Control Module Keep Alive Memory (KAM) Error
Diagnostic trouble codes · Vehicles built from Nov 2005
CAUTION / NOTICE / HINT
- NOTICE:
- When an injector is replaced, the injector's compensation code must be input into the ECM.
When the ECM is changed, all of the existing injector compensation codes must be input into the new ECM.
- An injector compensation code is unique. The 10-digit alphanumeric code imprinted on the head portion of an injector. If an incorrect injector compensation code is input into the ECM, the engine assembly may rattle or engine idling may become rough. In addition, engine failure may occur and the life of the engine may be shortened.
- When an injector is replaced, the injector's compensation code must be input into the ECM.
| When you replace the ECM with a new one, input all the injectors' compensation codes into the new ECM as follows: |
Prior to replacing the ECM, read and save each injector's compensation code, stored in the original ECM, using an intelligent tester (Click here).
After installing a new ECM, input the saved compensation codes into the new ECM using the tester (Click here).
Turn the tester off and turn the ignition switch off.
Wait for at least 30 seconds.
Turn the ignition switch on (IG) and then turn the tester on.
Clear DTC P0603 stored in the ECM using the tester (Click here).
- HINT:
- Each injector has different fuel injection characteristics. In order to optimize the fuel injections, the ECM uses the compensation codes to balance the different fuel injections between each injector.
- When you first turn the ignition on (IG) after replacing the ECM or an injector(s), DTC P0603 is set. This is to inform you that an injector compensation code(s) is/are required to be registered. Manually clear the DTC upon completion of the compensation code registration.
- Each injector has different fuel injection characteristics. In order to optimize the fuel injections, the ECM uses the compensation codes to balance the different fuel injections between each injector.
DESCRIPTION
| DTC No. |
DTC Detection Conditions |
Trouble Areas |
| P0603 |
Injector compensation code not registered (The MIL is illuminated and a DTC is immediately set when a malfunction is detected) |
|
- HINT:
- DTC P0603 is set when the ignition switch is in the on (IG) position.
INSPECTION PROCEDURE
| 1. CHECK INJECTOR COMPENSATION CODE |
Check the injector compensation code (Click here).
- OK:
- The compensation codes stored in the ECM match the compensation codes of the installed injectors.
|
|
||||
| OK | ||
| ||
