2005-2008 Yaris · Service Manual BRAKE

C1336/39 Zero Point Calibration of Acceleration Sensor Undone

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

A new skid control ECU is supplied without zero point calibration for the deceleration sensor and master cylinder pressure sensor. Until the zero points are calibrated, DTC C1336/39 remains stored. By entering test mode, the zero point calibration is automatically performed, and DTC C1336/39 is erased automatically.
DTC No.
Detecting Condition
Trouble Areas
C1336/39
When either of following conditions (1 or 2) detected:
  1. Vehicle driven without completion of zero point calibration.
  2. After zero point has been obtained, zero point voltage of sensor not between 2.38 V and 2.62 V.
  1. ABS and TRACTION actuator (skid control ECU)
  2. Zero point calibration incomplete

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).

HINT:
When U0123/62, U0124/69 or U0126/63 is output together with C1336/39, inspect and repair trouble areas indicated by U0123/62, U0124/69 or U0126/63 first.


1. CHECK YAW RATE SENSOR INSTALLATION
  1. Check that the yaw rate sensor has been installed properly (Click here).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not tilted.



NG
INSTALL YAW RATE SENSOR CORRECTLY
OK


2. PERFORM DECELERATION SENSOR ZERO POINT CALIBRATION
  1. Perform zero point calibration of the deceleration sensor (Click here).


NEXT


3. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Drive the vehicle and turn the steering wheel to the right and left at a speed of 45 km/h (28 mph) or more.

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B

    HINT:
    1. The DTC is set if the zero point calibration has not been completed successfully.
    2. End the procedure when the same DTC is not set after completion of the zero point calibration.



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C1300/62 Skid Control ECU Malfunction (from Nov 2005)C1370/73 Engine or Transmission System Matching Error (from Nov 2005) →