2005-2008 Yaris · Service Manual ENGINE

U0101 Lost Communication with TCM

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

The ECM and transmission control ECU communicate with each other via the CAN communication line. The transmission control ECU also communicates with other computers through the ECM. If there is a problem in this communication, the ECM sets the DTC.
DTC No.
DTC Detecting Conditions
Trouble Areas
U0101
Following conditions are met for 2 seconds (1 trip detection logic):
  1. Ignition switch on (IG)
  2. Battery voltage 10.8 V or more
  3. No communication between ECM and transmission control ECU
  1. Wire harness (CAN+, CAN- circuit)
  2. ECM
  3. Transmission control ECU assembly

WIRING DIAGRAM

C127411E01

INSPECTION PROCEDURE

HINT:
  1. Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.
  2. If the CAN communication malfunctions, there is no data output from the ECM. In this case, some of the freeze frame data are not correct and not identical with the ECM data, however the ECM data are correct.
  3. The malfunctioning area can be checked using the BUS CHECK on the intelligent tester (Click here).
  4. Refer to the inspection procedure for the CAN communication system (Click here).


← P2138 Throttle / Pedal Position Sensor / Switch "D" / "E" Voltage Correlation (from Aug 2005)ECM Power Source Circuit (from Aug 2005) →