2005-2008 Yaris · Service Manual BRAKE

C1251/51 Open in Pump Motor Circuit

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

DTC No.
DTC Detecting Condition
Trouble Areas
C1251/51
When any of following conditions detected with normal battery voltage (10 V or more):
  1. Open in pump motor power supply circuit or open in motor power supply circuit ground
  2. Motor stuck mechanically and does not operate
  3. Motor coil shorted and overcurrent flows
  1. ABS1/VSC1 fuse
  2. Brake actuator

WIRING DIAGRAM

C129339E03

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MOTOR RELAY)

  1. A107926E08
    Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester on.

  1. Clear the DTC (Click here).

  1. Perform the active test using the intelligent tester.Select the following menu items: Chassis / ABS/VSC/TRC / Active Test.

    ACTIVE TEST: ABS 
    Item (Display)
    Vehicle Condition : Test Details
    Diagnostic Note
    Motor Relay
    Turns ABS motor relay ON or OFF
    Operating sound of motor can be heard

  1. Check the operation sound of the ABS motor when operating it with the intelligent tester.

    OK:
    The operation sound of the ABS motor can be heard.



NG
Go to step 4
OK


2. INSPECT FUSE (ABS1/VSC1)

  1. C117863E05
    Remove the ABS1/VSC1 fuse from the engine room R/B.

  1. Measure the resistance.

    Standard Resistance:
    Below 1 Ω



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (BATTERY - SKID CONTROL ECU - BODY GROUND)

  1. C129347E01
    Disconnect the skid control ECU connector.

  1. Measure the voltage.

    Standard Voltage:
    Tester Connection
    Specified Condition
    A39-1 (BM) - Body ground
    10 to 14 V

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Specified Condition
    A39-13 (GND1) - Body ground
    Below 1 Ω
    A39-26 (GND1) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Check if the same DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE BRAKE ACTUATOR


← C1249/49 Open in Stop Light Switch Circuit (from Nov 2005)C1300/62 Skid Control ECU Malfunction (from Nov 2005) →