VEHICLE STABILITY CONTROL SYSTEM > TRC OFF Indicator Light Remains ON |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU connector is securely connected.
|
| ||||
| OK | |
| 3.INSPECT BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 4.READ VALUE USING INTELLIGENT TESTER (VSC OFF SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the engine switch to ON.
Select the Data List on the intelligent tester (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| TRC/VSC Off Mode | TRC/VSC off mode / Normal, TRC OFF or VSC OFF | Normal: Normal mode TRC OFF: TRC OFF mode VSC OFF: VSC OFF mode | - |
Using the intelligent tester, check the switch condition on the intelligent tester changes according to VSC OFF switch operation.
|
| ||||
| OK | |
| 5.REPLACE COMBINATION METER ASSEMBLY |
Turn the ignition switch off.
Replace the combination meter.
| NEXT | |
| 6.CHECK THAT TRC OFF INDICATOR IS ILLUMINATED |
Check if the TRC OFF indicator is illuminated when the ignition switch is turned to ON.
| Result | Proceed to |
| OK | A |
| NG (for Sedan) | B |
| NG (for Hatchback) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 7.INSPECT VSC OFF SWITCH |
![]() |
Turn the ignition switch off.
Disconnect the VSC OFF switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 (E) - 9 (+) | Switch is pushed in | Below 1 Ω |
| 6 (E) - 9 (+) | Switch is not pushed in | 10 kΩ or higher |
| *1 | Component without harness connected (VSC OFF Switch) |
| Result | Proceed to |
| OK | A |
| NG (for Sedan) | B |
| NG (for Hatchback) | C |
|
| ||||
|
| ||||
| A | |
| 8.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
Connect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A31-30 (CSW) - D106-9 (+) | Always | Below 1 Ω |
| A31-30 (CSW) - Body ground | Always | 10 kΩ or higher |
| D106-6 (E) - Body ground | Always | Below 1 Ω |
| Result | Proceed to |
| OK (for Sedan) | A |
| OK (for Hatchback) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||