ANTI-LOCK BRAKE SYSTEM > ABS Warning Light Remains ON |

| 1.CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU connector is securely connected.
|
| ||||
| OK | |
| 2.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 3.INSPECT BATTERY |
Check the battery voltage.
| Result | Proceed to |
| OK | A |
| NG (for 1NZ-FE) | B |
| NG (for 2NZ-FE) | C |
|
| ||||
|
| ||||
| A | |
| 4.CHECK TERMINAL VOLTAGE (IG1 TERMINAL) |
Disconnect the skid control ECU (brake actuator assembly) connector.
Turn the ignition switch to ON.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A55-34 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Skid control ECU) |
Turn the ignition switch off.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (GND1 TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A55-1 (GND1) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Skid control ECU) |
Reconnect the skid control ECU (brake actuator assembly) connector.
|
| ||||
| OK | |
| 6.READ VALUE USING INTELLIGENT TESTER (ABS WARNING LIGHT) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| ABS Warning Light | ABS warning light / OFF or ON | OFF | - |
When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| ABS Warning Light | ABS warning light | Warning light ON/OFF | Observe the combination meter. |
| Result | Proceed to | |
| Data List Display | Data List Display when Performing Active Test ON/OFF Operation | |
| ON | Changes between ON and OFF | A |
| Does not change between ON and OFF (for LHD) | B | |
| Does not change between ON and OFF (for RHD) | C | |
| OFF | Changes between ON and OFF | A |
| Does not change between ON and OFF (for LHD) | B | |
| Does not change between ON and OFF (for RHD) | C | |
|
| ||||
|
| ||||
| A | |
| 7.REPLACE COMBINATION METER ASSEMBLY |
Turn the ignition switch off.
Replace the combination meter assembly (Click here).
| NEXT | |
| 8.CHECK COMBINATION METER ASSEMBLY |
Connect the intelligent tester to the DLC3.
Perform Active Test of the combination meter assembly using the intelligent tester (Click here).
| Result | Proceed to |
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
|
| ||||
|
| ||||
| A | ||
| ||