KEY REMINDER WARNING SYSTEM > Key Reminder Buzzer does not Sound |

| 1.READ VALUE USING INTELLIGENT TESTER (FRONT DOOR COURTESY LIGHT SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FL Door Courtesy | Front LH door courtesy light switch signal / ON or OFF | ON: Front LH door closed OFF: Front LH door opened | - |
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (KEY UNLOCK WARNING SW) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key Unlock Warning SW | Unlock warning switch signal / OFF or ON | OFF: Ignition key is not inserted ON: Ignition key is inserted | - |
|
| ||||
| OK | |
| 3.CHECK COMBINATION METER ASSEMBLY (BUZZER OPERATION) |
Remove the key from the key cylinder, turn the light control switch on the headlight dimmer switch assembly to the tail position, and open the driver door.
|
| ||||
| OK | ||
| ||
| 4.INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
Inspect the unlock warning switch assembly (Click here).
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - UNLOCK WARNING SWITCH ASSEMBLY) |
Disconnect the F15 unlock warning switch and F76 main body ECU connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F15-1 - F76-17 (KSW) | Always | Below 1 Ω |
| F15-2 - Body ground | Always | Below 1 Ω |
| F15-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||